Calchy.
Tire size comparison

245/45R17 vs 245/40R18

Overall diameter, sidewall, revs per mile, and speedometer error — 245/40R18 is the taller tire, with a 0.1% speedo delta when swapping.

245/45R17
25.68in
652 mm overall diameter
245/40R18
25.72in
653 mm overall diameter
Diameter Δ
0.04 in
Speedo error
0.1%
245/45R17 revs/mi
785
245/40R18 revs/mi
784

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

245/45R17Ø 25.68245/40R18Ø 25.72
Full spec

Side by side

Metric245/45R17245/40R18
Section width245 mm245 mm
Aspect ratio4540
Wheel diameter1718
Sidewall height110 mm98 mm
Overall diameter25.68 in (652 mm)25.72 in (653 mm)
Circumference80.68 in80.79 in
Revolutions / mile785784
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 245/45R17 and 245/40R18?
245/45R17 has an overall diameter of 25.68 inches (652 mm). 245/40R18 is 25.72 inches (653 mm). That's a 0.04 inch (1 mm) difference — 245/40R18 is taller.
Will 245/40R18 cause speedometer error on a car fitted with 245/45R17?
Swapping 245/45R17 for 245/40R18 produces a speedometer error of about 0.1%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.1 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
245/45R17 turns 785 revs per mile. 245/40R18 turns 784 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
245/45R17 has a sidewall of 110 mm (4.34 in). 245/40R18 sidewall is 98 mm (3.86 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 245/40R18 a safe plus-size upgrade from 245/45R17?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 0.1%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools