Calchy.
Tire size comparison

235/45R18 vs 245/40R18

Overall diameter, sidewall, revs per mile, and speedometer error — 235/45R18 is the taller tire, with a 2.3% speedo delta when swapping.

235/45R18
26.33in
669 mm overall diameter
245/40R18
25.72in
653 mm overall diameter
Diameter Δ
0.61 in
Speedo error
2.3%
235/45R18 revs/mi
766
245/40R18 revs/mi
784

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

235/45R18Ø 26.33245/40R18Ø 25.72
Full spec

Side by side

Metric235/45R18245/40R18
Section width235 mm245 mm
Aspect ratio4540
Wheel diameter1818
Sidewall height106 mm98 mm
Overall diameter26.33 in (669 mm)25.72 in (653 mm)
Circumference82.71 in80.79 in
Revolutions / mile766784
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 235/45R18 and 245/40R18?
235/45R18 has an overall diameter of 26.33 inches (669 mm). 245/40R18 is 25.72 inches (653 mm). That's a 0.61 inch (16 mm) difference — 245/40R18 is shorter.
Will 245/40R18 cause speedometer error on a car fitted with 235/45R18?
Swapping 235/45R18 for 245/40R18 produces a speedometer error of about 2.3%. Your speedometer will read higher than your actual speed — a 60 mph indicated reading is really 58.6 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
235/45R18 turns 766 revs per mile. 245/40R18 turns 784 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
235/45R18 has a sidewall of 106 mm (4.16 in). 245/40R18 sidewall is 98 mm (3.86 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 245/40R18 a safe plus-size upgrade from 235/45R18?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 2.3%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools