Calchy.
Tire size comparison

245/40R18 vs 255/35R19

Overall diameter, sidewall, revs per mile, and speedometer error — 255/35R19 is the taller tire, with a 1.2% speedo delta when swapping.

245/40R18
25.72in
653 mm overall diameter
255/35R19
26.03in
661 mm overall diameter
Diameter Δ
0.31 in
Speedo error
1.2%
245/40R18 revs/mi
784
255/35R19 revs/mi
775

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

245/40R18Ø 25.72255/35R19Ø 26.03
Full spec

Side by side

Metric245/40R18255/35R19
Section width245 mm255 mm
Aspect ratio4035
Wheel diameter1819
Sidewall height98 mm89 mm
Overall diameter25.72 in (653 mm)26.03 in (661 mm)
Circumference80.79 in81.77 in
Revolutions / mile784775
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 245/40R18 and 255/35R19?
245/40R18 has an overall diameter of 25.72 inches (653 mm). 255/35R19 is 26.03 inches (661 mm). That's a 0.31 inch (8 mm) difference — 255/35R19 is taller.
Will 255/35R19 cause speedometer error on a car fitted with 245/40R18?
Swapping 245/40R18 for 255/35R19 produces a speedometer error of about 1.2%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.7 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
245/40R18 turns 784 revs per mile. 255/35R19 turns 775 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
245/40R18 has a sidewall of 98 mm (3.86 in). 255/35R19 sidewall is 89 mm (3.51 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 255/35R19 a safe plus-size upgrade from 245/40R18?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 1.2%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools