Calchy.
Tire size comparison

245/45R17 vs 265/35R19

Overall diameter, sidewall, revs per mile, and speedometer error — 265/35R19 is the taller tire, with a 2.4% speedo delta when swapping.

245/45R17
25.68in
652 mm overall diameter
265/35R19
26.3in
668 mm overall diameter
Diameter Δ
0.62 in
Speedo error
2.4%
245/45R17 revs/mi
785
265/35R19 revs/mi
767

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

245/45R17Ø 25.68265/35R19Ø 26.30
Full spec

Side by side

Metric245/45R17265/35R19
Section width245 mm265 mm
Aspect ratio4535
Wheel diameter1719
Sidewall height110 mm93 mm
Overall diameter25.68 in (652 mm)26.3 in (668 mm)
Circumference80.68 in82.63 in
Revolutions / mile785767
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 245/45R17 and 265/35R19?
245/45R17 has an overall diameter of 25.68 inches (652 mm). 265/35R19 is 26.3 inches (668 mm). That's a 0.62 inch (16 mm) difference — 265/35R19 is taller.
Will 265/35R19 cause speedometer error on a car fitted with 245/45R17?
Swapping 245/45R17 for 265/35R19 produces a speedometer error of about 2.4%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 61.5 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
245/45R17 turns 785 revs per mile. 265/35R19 turns 767 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
245/45R17 has a sidewall of 110 mm (4.34 in). 265/35R19 sidewall is 93 mm (3.65 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 265/35R19 a safe plus-size upgrade from 245/45R17?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 2.4%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools