Calchy.
Tire size comparison

245/40R19 vs 255/35R19

Overall diameter, sidewall, revs per mile, and speedometer error — 245/40R19 is the taller tire, with a 2.6% speedo delta when swapping.

245/40R19
26.72in
679 mm overall diameter
255/35R19
26.03in
661 mm overall diameter
Diameter Δ
0.69 in
Speedo error
2.6%
245/40R19 revs/mi
755
255/35R19 revs/mi
775

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

245/40R19Ø 26.72255/35R19Ø 26.03
Full spec

Side by side

Metric245/40R19255/35R19
Section width245 mm255 mm
Aspect ratio4035
Wheel diameter1919
Sidewall height98 mm89 mm
Overall diameter26.72 in (679 mm)26.03 in (661 mm)
Circumference83.93 in81.77 in
Revolutions / mile755775
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 245/40R19 and 255/35R19?
245/40R19 has an overall diameter of 26.72 inches (679 mm). 255/35R19 is 26.03 inches (661 mm). That's a 0.69 inch (18 mm) difference — 255/35R19 is shorter.
Will 255/35R19 cause speedometer error on a car fitted with 245/40R19?
Swapping 245/40R19 for 255/35R19 produces a speedometer error of about 2.6%. Your speedometer will read higher than your actual speed — a 60 mph indicated reading is really 58.5 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
245/40R19 turns 755 revs per mile. 255/35R19 turns 775 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
245/40R19 has a sidewall of 98 mm (3.86 in). 255/35R19 sidewall is 89 mm (3.51 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 255/35R19 a safe plus-size upgrade from 245/40R19?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 2.6%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools