Calchy.
Tire size comparison

235/45R18 vs 245/40R19

Overall diameter, sidewall, revs per mile, and speedometer error — 245/40R19 is the taller tire, with a 1.5% speedo delta when swapping.

235/45R18
26.33in
669 mm overall diameter
245/40R19
26.72in
679 mm overall diameter
Diameter Δ
0.39 in
Speedo error
1.5%
235/45R18 revs/mi
766
245/40R19 revs/mi
755

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

235/45R18Ø 26.33245/40R19Ø 26.72
Full spec

Side by side

Metric235/45R18245/40R19
Section width235 mm245 mm
Aspect ratio4540
Wheel diameter1819
Sidewall height106 mm98 mm
Overall diameter26.33 in (669 mm)26.72 in (679 mm)
Circumference82.71 in83.93 in
Revolutions / mile766755
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 235/45R18 and 245/40R19?
235/45R18 has an overall diameter of 26.33 inches (669 mm). 245/40R19 is 26.72 inches (679 mm). That's a 0.39 inch (10 mm) difference — 245/40R19 is taller.
Will 245/40R19 cause speedometer error on a car fitted with 235/45R18?
Swapping 235/45R18 for 245/40R19 produces a speedometer error of about 1.5%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.9 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
235/45R18 turns 766 revs per mile. 245/40R19 turns 755 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
235/45R18 has a sidewall of 106 mm (4.16 in). 245/40R19 sidewall is 98 mm (3.86 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 245/40R19 a safe plus-size upgrade from 235/45R18?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 1.5%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools