Calchy.
Tire size comparison

225/40R19 vs 245/40R19

Overall diameter, sidewall, revs per mile, and speedometer error — 245/40R19 is the taller tire, with a 2.4% speedo delta when swapping.

225/40R19
26.09in
663 mm overall diameter
245/40R19
26.72in
679 mm overall diameter
Diameter Δ
0.63 in
Speedo error
2.4%
225/40R19 revs/mi
773
245/40R19 revs/mi
755

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

225/40R19Ø 26.09245/40R19Ø 26.72
Full spec

Side by side

Metric225/40R19245/40R19
Section width225 mm245 mm
Aspect ratio4040
Wheel diameter1919
Sidewall height90 mm98 mm
Overall diameter26.09 in (663 mm)26.72 in (679 mm)
Circumference81.95 in83.93 in
Revolutions / mile773755
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 225/40R19 and 245/40R19?
225/40R19 has an overall diameter of 26.09 inches (663 mm). 245/40R19 is 26.72 inches (679 mm). That's a 0.63 inch (16 mm) difference — 245/40R19 is taller.
Will 245/40R19 cause speedometer error on a car fitted with 225/40R19?
Swapping 225/40R19 for 245/40R19 produces a speedometer error of about 2.4%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 61.4 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
225/40R19 turns 773 revs per mile. 245/40R19 turns 755 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
225/40R19 has a sidewall of 90 mm (3.54 in). 245/40R19 sidewall is 98 mm (3.86 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 245/40R19 a safe plus-size upgrade from 225/40R19?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 2.4%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools