Calchy.
Tire size comparison

265/30R19 vs 285/30R19

Overall diameter, sidewall, revs per mile, and speedometer error — 285/30R19 is the taller tire, with a 1.9% speedo delta when swapping.

265/30R19
25.26in
642 mm overall diameter
285/30R19
25.73in
654 mm overall diameter
Diameter Δ
0.47 in
Speedo error
1.9%
265/30R19 revs/mi
798
285/30R19 revs/mi
784

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

265/30R19Ø 25.26285/30R19Ø 25.73
Full spec

Side by side

Metric265/30R19285/30R19
Section width265 mm285 mm
Aspect ratio3030
Wheel diameter1919
Sidewall height80 mm86 mm
Overall diameter25.26 in (642 mm)25.73 in (654 mm)
Circumference79.36 in80.84 in
Revolutions / mile798784
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 265/30R19 and 285/30R19?
265/30R19 has an overall diameter of 25.26 inches (642 mm). 285/30R19 is 25.73 inches (654 mm). That's a 0.47 inch (12 mm) difference — 285/30R19 is taller.
Will 285/30R19 cause speedometer error on a car fitted with 265/30R19?
Swapping 265/30R19 for 285/30R19 produces a speedometer error of about 1.9%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 61.1 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
265/30R19 turns 798 revs per mile. 285/30R19 turns 784 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
265/30R19 has a sidewall of 80 mm (3.13 in). 285/30R19 sidewall is 86 mm (3.37 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 285/30R19 a safe plus-size upgrade from 265/30R19?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 1.9%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools