Calchy.
Tire size comparison

275/35R18 vs 285/30R19

Overall diameter, sidewall, revs per mile, and speedometer error — 285/30R19 is the taller tire, with a 0.6% speedo delta when swapping.

275/35R18
25.58in
650 mm overall diameter
285/30R19
25.73in
654 mm overall diameter
Diameter Δ
0.15 in
Speedo error
0.6%
275/35R18 revs/mi
788
285/30R19 revs/mi
784

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

275/35R18Ø 25.58285/30R19Ø 25.73
Full spec

Side by side

Metric275/35R18285/30R19
Section width275 mm285 mm
Aspect ratio3530
Wheel diameter1819
Sidewall height96 mm86 mm
Overall diameter25.58 in (650 mm)25.73 in (654 mm)
Circumference80.36 in80.84 in
Revolutions / mile788784
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 275/35R18 and 285/30R19?
275/35R18 has an overall diameter of 25.58 inches (650 mm). 285/30R19 is 25.73 inches (654 mm). That's a 0.15 inch (4 mm) difference — 285/30R19 is taller.
Will 285/30R19 cause speedometer error on a car fitted with 275/35R18?
Swapping 275/35R18 for 285/30R19 produces a speedometer error of about 0.6%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.4 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
275/35R18 turns 788 revs per mile. 285/30R19 turns 784 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
275/35R18 has a sidewall of 96 mm (3.79 in). 285/30R19 sidewall is 86 mm (3.37 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 285/30R19 a safe plus-size upgrade from 275/35R18?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 0.6%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools