Calchy.
Tire size comparison

255/35R19 vs 275/35R19

Overall diameter, sidewall, revs per mile, and speedometer error — 275/35R19 is the taller tire, with a 2.1% speedo delta when swapping.

255/35R19
26.03in
661 mm overall diameter
275/35R19
26.58in
675 mm overall diameter
Diameter Δ
0.55 in
Speedo error
2.1%
255/35R19 revs/mi
775
275/35R19 revs/mi
759

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

255/35R19Ø 26.03275/35R19Ø 26.58
Full spec

Side by side

Metric255/35R19275/35R19
Section width255 mm275 mm
Aspect ratio3535
Wheel diameter1919
Sidewall height89 mm96 mm
Overall diameter26.03 in (661 mm)26.58 in (675 mm)
Circumference81.77 in83.5 in
Revolutions / mile775759
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 255/35R19 and 275/35R19?
255/35R19 has an overall diameter of 26.03 inches (661 mm). 275/35R19 is 26.58 inches (675 mm). That's a 0.55 inch (14 mm) difference — 275/35R19 is taller.
Will 275/35R19 cause speedometer error on a car fitted with 255/35R19?
Swapping 255/35R19 for 275/35R19 produces a speedometer error of about 2.1%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 61.3 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
255/35R19 turns 775 revs per mile. 275/35R19 turns 759 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
255/35R19 has a sidewall of 89 mm (3.51 in). 275/35R19 sidewall is 96 mm (3.79 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 275/35R19 a safe plus-size upgrade from 255/35R19?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 2.1%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools