Calchy.
Tire size comparison

255/40R19 vs 265/35R19

Overall diameter, sidewall, revs per mile, and speedometer error — 255/40R19 is the taller tire, with a 2.7% speedo delta when swapping.

255/40R19
27.03in
687 mm overall diameter
265/35R19
26.3in
668 mm overall diameter
Diameter Δ
0.73 in
Speedo error
2.7%
255/40R19 revs/mi
746
265/35R19 revs/mi
767

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

255/40R19Ø 27.03265/35R19Ø 26.30
Full spec

Side by side

Metric255/40R19265/35R19
Section width255 mm265 mm
Aspect ratio4035
Wheel diameter1919
Sidewall height102 mm93 mm
Overall diameter27.03 in (687 mm)26.3 in (668 mm)
Circumference84.92 in82.63 in
Revolutions / mile746767
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 255/40R19 and 265/35R19?
255/40R19 has an overall diameter of 27.03 inches (687 mm). 265/35R19 is 26.3 inches (668 mm). That's a 0.73 inch (19 mm) difference — 265/35R19 is shorter.
Will 265/35R19 cause speedometer error on a car fitted with 255/40R19?
Swapping 255/40R19 for 265/35R19 produces a speedometer error of about 2.7%. Your speedometer will read higher than your actual speed — a 60 mph indicated reading is really 58.4 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
255/40R19 turns 746 revs per mile. 265/35R19 turns 767 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
255/40R19 has a sidewall of 102 mm (4.02 in). 265/35R19 sidewall is 93 mm (3.65 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 265/35R19 a safe plus-size upgrade from 255/40R19?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 2.7%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools