Calchy.
Tire size comparison

275/35R21 vs 285/30R22

Overall diameter, sidewall, revs per mile, and speedometer error — 285/30R22 is the taller tire, with a 0.5% speedo delta when swapping.

275/35R21
28.58in
726 mm overall diameter
285/30R22
28.73in
730 mm overall diameter
Diameter Δ
0.15 in
Speedo error
0.5%
275/35R21 revs/mi
706
285/30R22 revs/mi
702

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

275/35R21Ø 28.58285/30R22Ø 28.73
Full spec

Side by side

Metric275/35R21285/30R22
Section width275 mm285 mm
Aspect ratio3530
Wheel diameter2122
Sidewall height96 mm86 mm
Overall diameter28.58 in (726 mm)28.73 in (730 mm)
Circumference89.78 in90.27 in
Revolutions / mile706702
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 275/35R21 and 285/30R22?
275/35R21 has an overall diameter of 28.58 inches (726 mm). 285/30R22 is 28.73 inches (730 mm). That's a 0.15 inch (4 mm) difference — 285/30R22 is taller.
Will 285/30R22 cause speedometer error on a car fitted with 275/35R21?
Swapping 275/35R21 for 285/30R22 produces a speedometer error of about 0.5%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.3 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
275/35R21 turns 706 revs per mile. 285/30R22 turns 702 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
275/35R21 has a sidewall of 96 mm (3.79 in). 285/30R22 sidewall is 86 mm (3.37 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 285/30R22 a safe plus-size upgrade from 275/35R21?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 0.5%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools