Calchy.
Tire size comparison

225/45R18 vs 225/40R19

Overall diameter, sidewall, revs per mile, and speedometer error — 225/40R19 is the taller tire, with a 0.4% speedo delta when swapping.

225/45R18
25.97in
660 mm overall diameter
225/40R19
26.09in
663 mm overall diameter
Diameter Δ
0.11 in
Speedo error
0.4%
225/45R18 revs/mi
777
225/40R19 revs/mi
773

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

225/45R18Ø 25.97225/40R19Ø 26.09
Full spec

Side by side

Metric225/45R18225/40R19
Section width225 mm225 mm
Aspect ratio4540
Wheel diameter1819
Sidewall height101 mm90 mm
Overall diameter25.97 in (660 mm)26.09 in (663 mm)
Circumference81.59 in81.95 in
Revolutions / mile777773
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 225/45R18 and 225/40R19?
225/45R18 has an overall diameter of 25.97 inches (660 mm). 225/40R19 is 26.09 inches (663 mm). That's a 0.11 inch (3 mm) difference — 225/40R19 is taller.
Will 225/40R19 cause speedometer error on a car fitted with 225/45R18?
Swapping 225/45R18 for 225/40R19 produces a speedometer error of about 0.4%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.3 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
225/45R18 turns 777 revs per mile. 225/40R19 turns 773 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
225/45R18 has a sidewall of 101 mm (3.99 in). 225/40R19 sidewall is 90 mm (3.54 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 225/40R19 a safe plus-size upgrade from 225/45R18?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 0.4%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools