Calchy.
Tire size comparison

275/35R20 vs 285/30R21

Overall diameter, sidewall, revs per mile, and speedometer error — 285/30R21 is the taller tire, with a 0.6% speedo delta when swapping.

275/35R20
27.58in
701 mm overall diameter
285/30R21
27.73in
704 mm overall diameter
Diameter Δ
0.15 in
Speedo error
0.6%
275/35R20 revs/mi
731
285/30R21 revs/mi
727

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

275/35R20Ø 27.58285/30R21Ø 27.73
Full spec

Side by side

Metric275/35R20285/30R21
Section width275 mm285 mm
Aspect ratio3530
Wheel diameter2021
Sidewall height96 mm86 mm
Overall diameter27.58 in (701 mm)27.73 in (704 mm)
Circumference86.64 in87.12 in
Revolutions / mile731727
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 275/35R20 and 285/30R21?
275/35R20 has an overall diameter of 27.58 inches (701 mm). 285/30R21 is 27.73 inches (704 mm). That's a 0.15 inch (4 mm) difference — 285/30R21 is taller.
Will 285/30R21 cause speedometer error on a car fitted with 275/35R20?
Swapping 275/35R20 for 285/30R21 produces a speedometer error of about 0.6%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.3 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
275/35R20 turns 731 revs per mile. 285/30R21 turns 727 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
275/35R20 has a sidewall of 96 mm (3.79 in). 285/30R21 sidewall is 86 mm (3.37 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 285/30R21 a safe plus-size upgrade from 275/35R20?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 0.6%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools