Calchy.
Tire size comparison

265/35R20 vs 275/35R20

Overall diameter, sidewall, revs per mile, and speedometer error — 275/35R20 is the taller tire, with a 1% speedo delta when swapping.

265/35R20
27.3in
694 mm overall diameter
275/35R20
27.58in
701 mm overall diameter
Diameter Δ
0.28 in
Speedo error
1%
265/35R20 revs/mi
739
275/35R20 revs/mi
731

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

265/35R20Ø 27.30275/35R20Ø 27.58
Full spec

Side by side

Metric265/35R20275/35R20
Section width265 mm275 mm
Aspect ratio3535
Wheel diameter2020
Sidewall height93 mm96 mm
Overall diameter27.3 in (694 mm)27.58 in (701 mm)
Circumference85.78 in86.64 in
Revolutions / mile739731
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 265/35R20 and 275/35R20?
265/35R20 has an overall diameter of 27.3 inches (694 mm). 275/35R20 is 27.58 inches (701 mm). That's a 0.28 inch (7 mm) difference — 275/35R20 is taller.
Will 275/35R20 cause speedometer error on a car fitted with 265/35R20?
Swapping 265/35R20 for 275/35R20 produces a speedometer error of about 1%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.6 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
265/35R20 turns 739 revs per mile. 275/35R20 turns 731 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
265/35R20 has a sidewall of 93 mm (3.65 in). 275/35R20 sidewall is 96 mm (3.79 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 275/35R20 a safe plus-size upgrade from 265/35R20?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 1%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools