Tire size comparison
245/35R20 vs 255/35R20
Overall diameter, sidewall, revs per mile, and speedometer error — 255/35R20 is the taller tire, with a 1% speedo delta when swapping.
245/35R20
26.75in
680 mm overall diameter
255/35R20
27.03in
687 mm overall diameter
Diameter Δ
0.28 in
Speedo error
1%
245/35R20 revs/mi
754
255/35R20 revs/mi
746
Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.
Full spec
Side by side
| Metric | 245/35R20 | 255/35R20 |
|---|---|---|
| Section width | 245 mm | 255 mm |
| Aspect ratio | 35 | 35 |
| Wheel diameter | 20″ | 20″ |
| Sidewall height | 86 mm | 89 mm |
| Overall diameter | 26.75 in (680 mm) | 27.03 in (687 mm) |
| Circumference | 84.04 in | 84.91 in |
| Revolutions / mile | 754 | 746 |
Related
Other comparisons for these sizes
FAQ
Frequently asked
- What is the diameter difference between 245/35R20 and 255/35R20?
- 245/35R20 has an overall diameter of 26.75 inches (680 mm). 255/35R20 is 27.03 inches (687 mm). That's a 0.28 inch (7 mm) difference — 255/35R20 is taller.
- Will 255/35R20 cause speedometer error on a car fitted with 245/35R20?
- Swapping 245/35R20 for 255/35R20 produces a speedometer error of about 1%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.6 mph. Anything under 3% is usually acceptable without recalibration.
- How many revolutions per mile does each size do?
- 245/35R20 turns 754 revs per mile. 255/35R20 turns 746 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
- What's the sidewall height difference?
- 245/35R20 has a sidewall of 86 mm (3.38 in). 255/35R20 sidewall is 89 mm (3.51 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
- Is 255/35R20 a safe plus-size upgrade from 245/35R20?
- A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 1%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools