Calchy.
Tire size comparison

315/30R22 vs 325/30R22

Overall diameter, sidewall, revs per mile, and speedometer error — 325/30R22 is the taller tire, with a 0.8% speedo delta when swapping.

315/30R22
29.44in
748 mm overall diameter
325/30R22
29.68in
754 mm overall diameter
Diameter Δ
0.24 in
Speedo error
0.8%
315/30R22 revs/mi
685
325/30R22 revs/mi
680

Within the ±3% overall-diameter band usually considered safe for plus-sizing — speedometer and ABS calibration should stay close to factory.

315/30R22Ø 29.44325/30R22Ø 29.68
Full spec

Side by side

Metric315/30R22325/30R22
Section width315 mm325 mm
Aspect ratio3030
Wheel diameter2222
Sidewall height95 mm98 mm
Overall diameter29.44 in (748 mm)29.68 in (754 mm)
Circumference92.49 in93.23 in
Revolutions / mile685680
Related

Other comparisons for these sizes

FAQ

Frequently asked

What is the diameter difference between 315/30R22 and 325/30R22?
315/30R22 has an overall diameter of 29.44 inches (748 mm). 325/30R22 is 29.68 inches (754 mm). That's a 0.24 inch (6 mm) difference — 325/30R22 is taller.
Will 325/30R22 cause speedometer error on a car fitted with 315/30R22?
Swapping 315/30R22 for 325/30R22 produces a speedometer error of about 0.8%. Your speedometer will read lower than your actual speed — a 60 mph indicated reading is really 60.5 mph. Anything under 3% is usually acceptable without recalibration.
How many revolutions per mile does each size do?
315/30R22 turns 685 revs per mile. 325/30R22 turns 680 revs per mile. Taller tyres turn fewer times per mile, which lowers effective final-drive ratio.
What's the sidewall height difference?
315/30R22 has a sidewall of 95 mm (3.72 in). 325/30R22 sidewall is 98 mm (3.84 in). Lower-profile sidewalls give sharper steering response but less bump compliance.
Is 325/30R22 a safe plus-size upgrade from 315/30R22?
A plus-size upgrade is considered safe when overall diameter stays within ±3% — here the difference is 0.8%. This swap is within the typical safe range; speedometer and ABS calibration should remain close to factory.
Related tools